Slate Air Dust Collector in Italy

The water wall dust extractor has a double dust suction system. Outside there is a waterfall layer, generated to capture the heavier dust in suspension; inside there is another nozzle reduction system, needed for the complete dust removal of the suctioned air. Our suction cabin is designed for high performance and less maintenance. It is made of prime AISI 304 stainless steel. The MB water wall follows the guidelines of HSE Health and Safety Executive.

The operation and use of the MODULBOX MB system requires the operator to work in the front of the module, between the water layer and the linear vacuum opening. The dust produced is vacuumed by the fans through the opening located between the tank and the water layer. At first, part of the dust is reduced by the outer water layer while the rest is stopped by a water atomization system located inside the machine. The module also has a droplet separator that isolates the water atomization system from the suction unit, not allowing the water or dust to be discharged in the air. The purified air comes out from the top of the machine, allowing recirculation in the location. The water flow on the outer layer can be regulated using the gate valves while the flow of the inner water atomization system, for dust reduction, remains constant. It is also possible to access the machine for cleaning and routine maintenance of parts subject to saturation and inevitable wear. An additional fixed or mobile box of various dimensions with a frame in AISI 304 stainless steel and plexiglass panels can be applied to the front allowing the user to work even in areas subject to excessive turbulence. Whenever the laboratory ceiling is not higher than six metres, our anti-turbulence disperser called the PLENUM is recommended.

It is powered by:

-A power panel that is up to EC standards and American UL-CSA

-Submersible pump with pump body and back side impeller in AISI 304 stainless steel

-Highly energy efficient motors (category IE3)

-Easily removable drawer droplet separators on the front

-The containment tank below it is tilted for easy cleaning of the accumulated sludge

DUST EXTRACTION BENCHES for efficient dust suction

The stone* dust extraction benches represent a very efficient solution for stone fabricator shops.
All our dust benches are made of a sturdy non vibrating metal structure, carefully protected by ceramic and epoxy paint to ensure a long lifetime. The work surface is made up of strong and resistant timber planks.

Features:
High dust suction and suppression power: the combination of a powerful motor, a high pressure fan and state-of-the-art suppression technologies will strongly reduce the amount of dust in your laboratory.
Immediately operational and user-friendly: the installation does not require masonry works, just connect to the needed electrical, water or pneumatic supplies (according to the model).
Reduced maintenance: Except the fan, Ghines dust extraction benches do not have pumps, filters or mechanically moving parts, which reduces maintenance to a minimum and which guarantees also intensive use in the long term.
XAGUA is a water-system suction bench for air cleaning, it uses the water to wet the stone* dust and ceramic dust
How does it work?
An impressive suction effect all over the perimeter of the XAGUA guides the stone* dust effectively inside the machine, where it is captured by nebulized water drops. The created air flow is forced several times to change direction and the centrifugal forces abate the muddy particles into the tank. Drop separators with lamellar structure inside the dust extraction bench retain the humidity inside. The continuous water overflow takes out the dirty water from the bench.
The compact and sturdy metal structure, protected by ceramic and epoxy paint, together with galvanized steel plates and the pvc drop separators assure a low sound pressure and the investment in the long term.
* some limitation on materials may apply, depending by your country. Please contact us for more information