Stone quarrying hydro bags are widely used in natural stone (marble, granite, basalt) quarrying to separate blocks from large masses in quarries. Hydro bags allow blocks of 1000 tons or more to be scrapped without the need to prepare slots to house jacks. The original thickness of the water bag is only 2 mm (0.08"), it can easily slip into a wire saw cut.
Quarry Hydro bags, also known as Water Bags, are expanding hydraulic cushions composed of two high tensile steel plates. The water bags expand under the pressure of pumped water at 30-40 bar, allowing a maximum expansion of 25-30 cm (approximately 1') and a thrust of up to 1000 tons.
The Hydro-bag is environmentally friendly as only running water (not oil as in hydraulic jacks) is the dilatation fluid. It is safe, even if the hydro-bag's cushion blows due to excessive inflation pressure there is no deflagration because water, not air, is the inflating media. The Hydro-bag does not require any maintenance, throw it away when it is no longer usable.
The thrust that can be obtained for a pillow can be up to 1000 tons. Combine two or more pads to achieve higher performance; side by side or together in packs.
The quarry hydraulic rock splitter consists of splitting cylinders and a power unit. Cylinders are powered by the high pressure power unit. Fuel tank piston and wedges are the main component of the cylinder. It needs a pre-drill hole of required depth down on the material for movement of the middle wedge. There is a valve on the top of cylinder to control piston work, when the power unit give pressure make the piston work, piston will pressure middle wedge move into bottom, and at the same time, middle wedge will push counter wedges move to sides, a huge horizontal splitting force is produced against to the hole wall, when the tension increases beyond the tensile strength of the material, a split will occur.
Suitable for pushing over the quarry stone after the cut is made by the diamond wire; Extremely slim makes it easy to be put into the cut made by diamond wire; Reusable for cost savings
Suitable for pushing over the quarry stone after the cut is made by the diamond wire; Extremely slim makes it easy to be put into the cut made by diamond wire; Reusable for cost savings.
Hydrobag is a pump for filling cushion with water, for borrow material excavation. Hydro bag is composed by: - pressure power unit Hydro bag with electric engine 5,5 Hp - supported wheelbarrow and water reservoir - safety and distribution valves - aspiration and pressure pipes and aspiration filter - Series of fast couplings - thrust up to 1000 tonnes, dilatation 25-30cm - supply plug and engine - saver interrupter. Cushions are available: CM 50x50, CM 80x80, CM 50X100, CM 100x100, CM 150x150.
THE HYDRO (WATER) BAG IS MANUFACTIRED FROM THE FINEST HIGH QUALITY TENSILE STEEL , HEREBY QUARANTEEING FLAWLESS PERFORMANCE .THE BAG IS INSERTED IN THE CRACK IN THE BLOCK AND IT SEPARATED THE BLOCK AS S0ON AS WATER IS INSERTED IN THE BAG WITH THE HELP OF THE WATER PUMP. DIMENSION 1 * 1 MTR 1 * 0.5 MTR
Nowadays, most mining and quarrying industries utilize a diamond wire saw machine for bench cutting operations. This method uses a metal wire or cable assembled by diamond beads to cut the hard stone into large blocks. Many parameters classied into controllable and uncontrollable parameters aect the performance of the diamond wire saw cutting meth-od. The uncontrollable parameters are related to rock engineering properties, and controllable parameters are related to operational aspects and mac
Bestlink Factory Price Quarry Block Air Bag Pushing for Marble Granite Quarry block pushing air bag is used to separate the marble, granite, stones (rock mass) block from the basic rock achieving a maximum opening of 45-120cm at the top. The air bag can separate the block (rock mass) which is having all side wire saw cut faces. The standard configuration set contains two air bags, with one set of air hose & air control panel. Our air pushing bag is manufactured with high-tech materials and proce
Hydro-bag This has happened in the marble and stone quarrying industry , specifically for stripping blocks from the mountain . HYDRO-BAG has completely upset bench excavation in quarries . The revolutionary aspect of the HYDRO-BAG equipment lies basically in the possibility of stripping blocks up to 1000 tons or more , without the need to prepare slots to house the jacks since the HYDRO-BAG has an original thickness of just 2 mm ( 0.08) and can be easily slipped into the wire saw cut . Crack-roc
Splitting cushions in polyester material spread with PVC and FH sealed. Instertable in size of 9mm with adequate protective sheet. Maximum inflated pressure 3 Atm. Max. split to a limit of 45 cm.Complete with an inflatable centre suitable for the use of maximum of 3 cushions simultaneously.
HYDRO BAG Tipping cushions using high pressure water HIDRO-BAG offer the following advantageous: features: -doesnt ruin the block -weight a mere 8 kg - it is only 2mm thick -can be iserted in the diamond r helicoidal saw cut -has a thrust development of 300 tons -works with water, at 30 atm only. -it is provided whit rapid coupling -does not required maintenance -can be thrown after use
Nowadays, most mining and quarrying industries utilize a diamond wire saw machine for bench cutting operations. This method uses a metal wire or cable assembled by diamond beads to cut the hard stone into large blocks. Many parameters classied into controllable and uncontrollable parameters aect the performance of the diamond wire saw cutting meth-od. The uncontrollable parameters are related to rock engineering properties, and controllable parameters are related to operational aspects and mac
Suitable for pushing over the quarry stone after the cut is made by the diamond wire; Extremely slim makes it easy to be put into the cut made by diamond wire; Reusable for cost savings
Suitable for pushing over the quarry stone after the cut is made by the diamond wire; Extremely slim makes it easy to be put into the cut made by diamond wire; Reusable for cost savings.
Stone quarrying hydro bags are widely used in natural stone (marble, granite, basalt) quarrying to separate blocks from large masses in quarries. Hydro bags allow blocks of 1000 tons or more to be scrapped without the need to prepare slots to house jacks. The original thickness of the water bag is only 2 mm (0.08"), it can easily slip into a wire saw cut.
Quarry Hydro bags, also known as Water Bags, are expanding hydraulic cushions composed of two high tensile steel plates. The water bags expand under the pressure of pumped water at 30-40 bar, allowing a maximum expansion of 25-30 cm (approximately 1') and a thrust of up to 1000 tons.
The Hydro-bag is environmentally friendly as only running water (not oil as in hydraulic jacks) is the dilatation fluid. It is safe, even if the hydro-bag's cushion blows due to excessive inflation pressure there is no deflagration because water, not air, is the inflating media. The Hydro-bag does not require any maintenance, throw it away when it is no longer usable.
The thrust that can be obtained for a pillow can be up to 1000 tons. Combine two or more pads to achieve higher performance; side by side or together in packs.
The quarry hydraulic rock splitter consists of splitting cylinders and a power unit. Cylinders are powered by the high pressure power unit. Fuel tank piston and wedges are the main component of the cylinder. It needs a pre-drill hole of required depth down on the material for movement of the middle wedge. There is a valve on the top of cylinder to control piston work, when the power unit give pressure make the piston work, piston will pressure middle wedge move into bottom, and at the same time, middle wedge will push counter wedges move to sides, a huge horizontal splitting force is produced against to the hole wall, when the tension increases beyond the tensile strength of the material, a split will occur.
Ask a Question
Could not find the answer you need? Ask about Travertine Quarry Hydro Bag.
Questions & Answers on Travertine Quarry Hydro Bag
What is Quarry Hydro-Bags maximum thrust force?View answer⌄
Asked by Visitor
The hydro bags expand under the pressure of water pumped at 30-40 bar, permitting a maximum dilatation of 25-30 cm (approx. 1’) and a thrust force up to 1000 tons. Couple two or more cushions to obtain higher performances; side by side or combined together in packs.
The working principle of quarry rock splitter is based on two counter wedges inserted in a pre-drilled hole. A hydraulic cylinder pushes out a centre wedge between the counter wedges to spread them apart and the rock is forced to crack.